Fluid - Transfer Case: Service and Repair

FLUID DRAIN / REFILL





The fill and drain plugs are both in the rear case (Fig. 92).

1. Raise vehicle.
2. Position drain pan under transfer case.
3. Remove drain and fill plugs and drain lubricant completely.
4. Install drain plug. Tighten plug to 20 - 34 Nm (15 - 25 ft. lbs.).
5. Remove drain pan.
6. Fill transfer case to bottom edge of fill plug opening with Mopar Transfer Case Lubricant.
7. Install and tighten fill plug to 20 - 34 Nm (15 - 25 ft. lbs.).
8. Lower vehicle.