Dome Lamp: Service and Repair

REMOVAL
It will be necessary to partially remove the headliner to remove the bulb socket.
1. Remove the screws holding the grab handle/ lens assembly to the headliner and roof panel.
2. Lower the headliner as needed.
3. Separate the lamp socket from the headliner and roof panel.
4. Disconnect the wire connector.

INSTALLATION
1. Position the lamp socket on the headliner and roof panel.
2. Connect the wire harness.
3. Install the headliner.
4. Position the grab handle/lens on the lamp module
5. Install the screws retaining the grab handle/ lens into the lamp socket.