Rear Door Stationary Window

DOOR GLASS

REMOVAL

1. Place door window fully down.
2. Remove waterdam. (Refer to Rear Door Panel).
3. Remove inner belt weatherstrip.
4. Remove bolt attaching bottom of rear glass run channel to door.
5. Pull run channel downward and separate from door.

Fig. 1:

6. Remove screws attaching stationary door glass frame to door. (Fig. 1).
7. Separate stationary door glass from door.

INSTALLATION

1. Position stationary door glass in door.
2. Install screws attaching stationary door glass frame to door.
3. Install glass run channel.
4. Install inner belt weatherstrip.
5. Install waterdam.