Body - Poor Air Deflector to Hood Fit
NUMBER: 23-026-03GROUP: Body
DATE: October 24, 2003
THIS BULLETIN IS BEING PROVIDED IN ADVANCE. DO NOT ORDER PARTS OR PERFORM ANY ACTIONS RELATED TO THIS BULLETIN UNTIL NOVEMBER 07, 2003.
SUBJECT:
New Snap-In Retainer To Improve Retention Of Mopar Air Deflector To Hood
OVERVIEW:
This bulletin involves the replacement of the front air deflector plastic snap-in retainers.
MODELS:
1999 - 2004 (WJ) Grand Cherokee (Domestic Markets)
SYMPTOM/CONDITION:
The Mopar front molded air deflector (bug shield) accessory is fastened to the underside of the hood. The inner hood panel has four slots to accommodate the air deflector plastic snap-in retainers. The customer may notice that the plastic snap-in retainers do not fully seat to the slots in the hood inner panel.
DIAGNOSIS:
If the plastic snap-in retainers for the Mopar air deflector are not fully seated to the slots in the hood inner panel, perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
1. Remove the four (4) fasteners securing the air deflector to the hood and remove the air deflector (Fig. 1).
2. Install the new plastic snap-in retainers, p/n 05134664AA.
3. Install the air deflector to the hood.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE: