Underhood Lamp: Service and Repair

REMOVAL
Bulb
1. Insert a small flat blade in access slot between the lamp base and lamp lens.

Underhood Lamp Lens:

2. Lift the lamp lens upward and remove the lamp lens.

Fig.35 Underhood Lamp Bulb:

3. Depress bulb terminal inward to release bulb.

Lamp
1. Disconnect the wire harness connector from lamp.

Fig.36 Underhood Lamp:

2. Remove the screw attaching underhood lamp to inner hood panel.
3. Remove the underhood lamp from the vehicle.

INSTALLATION
Bulb
1. Engage the replacement bulb wire loop to terminal closest to lamp base wire connector.
2. Depress the opposite terminal inward and engage the remaining bulb wire loop.
3. Position the lamp lens on the lamp base and press into place.

Lamp
1. Position the underhood lamp on the hood inner panel.
2. Install the screw attaching the lamp base to the inner hood panel.
3. Install the lamp housing and press into place.
4. Connect the wire harness connector.