License Plate Lamp Unit Replacement

Fig.21 License Plate Lamp Housing:

REMOVAL
1. Remove the screws retaining the lamp housing/trim panel to the liftgate.
2. Disconnect the wire harness for the license plate lamps and the flip up glass switch, if equipped.
3. Remove the license plate lamps and the flip up glass switch, if equipped.
4. Remove the license plate lamp housing.

INSTALLATION
1. Install the license plate lamps, and the flip up glass switch, if equipped.
2. Connect the wire harnesses for the license plate lamps and the flip up glass switch.
3. Install the lamp housing/trim panel on the liftgate.