License Plate Lamp Replacement

REMOVAL
Bulb
1. Remove lamp assembly from liftgate lamp module.
2. Rotate bulb socket counterclockwise to disconnect bulb socket from lamp.
3. Remove bulb from socket.

Fig.20 License Plate Lamp Housing:

Lamp
1. Remove the screws attaching lamp assembly to liftgate..
2. Pull the lamp assembly away from the sheet-metal at extreme outboard edges to disengage the push pins.
3. Separate lamp assembly harness wiring connector.
4. Remove lamp.

INSTALLATION
Bulb
1. Install bulb in socket.
2. Install socket and bulb assembly in lamp housing.
3. Install lamp assembly in liftgate lamp module.

Lamp
1. Connect bulb harness to lamp assembly.
2. Position lamp assembly on liftgate and press outboard fasteners in place
3. Install screws in lamp assembly