Rear Seat Cushion Release Latch

REAR SEAT CUSHION RELEASE LATCH

REMOVAL

1. Unlatch seat and pivot seat upward.
2. Disengage J-strap at seat cushion base panel.
3. Roll back cushion cover.
4. Remove screws attaching latch to base panel.
5. Separate latch from base panel.

INSTALLATION

1. Position latch on base panel.
2. Install screws attaching latch to base panel. Tighten screws to 8 N.m (75 in. lbs.) torque.
3. Route the cushion release strap from the loop on the latch through the slot in the trim cover.
4. Engage J-strap at seat cushion base panel.
5. latch seat.