Rear Seat Back

REAR SEAT BACK

REMOVAL

1. Move rear seat cushions to forward cargo position.

Fig. 11:

2. Remove bolts attaching seatback side support bracket to floor pan (right side) (Fig. 11).
3. Tilt seatback forward, and slide it outboard to detach it from pin on center pivot bracket.
4. Remove right side (60%) seatback from vehicle.
5. Remove bolts attaching seatback side support bracket and center pivot bracket to floor pan (left side).
6. Remove left side (40%) seatback from vehicle.

INSTALLATION

1. Position left side (40%) seatback in vehicle.
2. Position left side support bracket and center pivot bracket with bolt holes aligned and install bolts. Tighten bolts to 50 N.m (37 ft.lbs.) torque.
3. Position right side (60%) seatback in vehicle.
4. Install seatback onto center pivot bracket pin. Ensure seat back is properly engaged on the center pivot pin.
5. Position right side support bracket with bolt holes aligned and install bolts. Tighten bolts to 50 N.m (37 ft.lbs.) torque.
6. Return seat cushions to seating position.