Folding Rear Seat Back Latch Handle

FOLDING REAR SEAT BACK LATCH HANDLE

REMOVAL

1. Pull handle to release latch.
2. Remove screws attaching release handle to seat back frame.
3. Using a small flat blade, disengage retainers securing latch release cable housing to latch release handle.
4. Rotate cable end until barrel end aligns with key hole slot in latch release handle.
5. Disengage cable barrel end from release handle.

Fig. 15:

6. Separate latch release handle from seat back (Fig. 15).

INSTALLATION

1. Route cable end into latch release handle.
2. Rotate cable end until barrel end aligns with key hole slot in latch release handle and insert into handle.
3. Engage retainers securing latch release cable housing to latch release handle.
4. Position latch release handle in seat back. Ensure seat back cover is properly aligned.
5. Install screws attaching release handle to seat back frame.