Folding Rear Seat Back Latch / Hinge

FOLDING REAR SEAT BACK LATCH / HINGE

REMOVAL

1. Remove seat back.
2. Disengage J-straps on outboard side of seat back.
3. Disengage release cable from latch.
4. Remove bolts attaching latch/hinge to seat back frame.
5. Separate latch/hinge from seat back frame.

INSTALLATION

1. Position latch/hinge on seat back frame.
2. Install bolts attaching latch/hinge to seat back frame. Tighten bolts to 50 N.m (37 ft.lbs.) torque.
3. Engage latch release cable.
4. Engage J-straps on outboard side of seat back.
5. Install seat back.