Procedures

GLASS PANEL

REMOVAL
1. Slide sunshade rearward to the open position.
2. Move the glass panel to the fully closed position.

Fig. 5 Sunroof Glass Panel Remove:

3. Remove the four attaching screws.
4. Lift off glass panel and remove from vehicle.

INSTALLATION


NOTE: Sunroof glass must be set in place and attached as close as possible to flush with the roof surface. For wind noise reasons, care must be taken to ensure that the glass is not remounted either a) Overflush to the roof surface at the front edge of the glass, or b) Underflush to the roof surface at the rear edge of the glass.


1. Position glass panel in to opening.
2. Start the four attaching screws.
3. Tighten screws.
4. Verify sunroof operation and alignment. Check fit and adjust as necessary.