Sunroof / Moonroof Panel: Adjustments

ADJUSTMENTS

ADJUSTMENTS - FIT

1. Move the sunshade rearward to the open position.
2. Move the sunroof glass panel to the fully closed position.
3. Loosen the forward screws on each side enough to make the front adjustment.
4. Adjust the front of the sunroof glass panel 1 mm (1/32 inch) below the top surface of the roof panel.
5. Tighten the front two screws.
6. Loosen the rear screws on each side enough to make the rear adjustment.
7. Adjust the rear of the sunroof glass panel 1 mm (1/32 inch) above the top surface of the roof panel.
8. Tighten the rear two screws.
9. Check for proper fit. If not OK, repeat glass panel adjustment.

ADJUSTMENT - TIMING

NOTE: A gage comes with the new motor.

1. If the glass panel was not in the fully closed position, when the motor was removed, the sunroof glass panel needs to be timed, before the new motor is installed.
2. Remove sunroof glass panel.

Fig. 6:

3. Set gage into the track near the rear of the opening between the driver slide and the bracket (Fig. 6).
4. Move the driver slide forward or aft to get proper setting.
5. Repeat the operation on the other side.
6. Install drive motor.