Trunk / Liftgate: Service and Repair

LIFTGATE

REMOVAL

CAUTION: Do not disconnect the support rod cylinders with the liftgate closed. The support rod pistons are operated by high pressure gas. This pressure could cause damage and / or personal injury if they are removed while the pistons are compressed.

1. Open and support the liftgate.
2. Remove the trim panel.
3. Remove the prop rods from the liftgate.
4. Disconnect the wire harnesses and the washer hose.
5. Using a grease pencil or equivalent, mark the hinge location.

Fig. 9:

6. Remove the liftgate to hinge screws and remove liftgate from vehicle. (Fig. 9)

INSTALLATION
1. Position the liftgate on the vehicle and align the witness marks.
2. Install the hinge screws at liftgate and tighten to 28 N.m (20 ft. lbs.).
3. Connect the wire harnesses and the washer hose.
4. Install the trim panel.
5. Install the prop rods.
6. Close the liftgate and check for proper latching and alignment. Adjust as necessary.