Speaker Replacement - Instrument Panel

INSTRUMENT PANEL SPEAKER

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the top cover from the instrument panel.

Fig. 21 Instrument Panel Speaker Remove/Install:

3. Disconnect the instrument panel wire harness connector from the speaker wire harness connector.
4. Remove the two screws that secure the speaker to the top of the instrument panel.
5. Remove the speaker from the top of instrument panel.

INSTALLATION
1. Position the speaker onto the top of the instrument panel.
2. Install and tighten the two screws that secure the speaker to the top of the instrument panel. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Reconnect the instrument panel wire harness connector to the speaker wire harness connector.
4. Install the top cover onto the instrument panel.
5. Reconnect the battery negative cable.