LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2002 >> Wrangler Sahara, Automatic >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Caliper & Brake Pads >> Installation

Front Brake Caliper & Brake Pads: Installation

NOTE: If new caliper mounting bolts are being installed or if reason for repair is to correct a drag or pull, check caliper bolt length. Correct caliper bolt shank length is 2.61-2.66" (66.4-67.6 mm) and thread length is 0.87" (22 mm). If caliper mounting bolts are too long they will contact inboard pad and cause a partial apply condition.
  1. To install, reverse removal procedure. Apply a light coat of multipurpose grease to caliper sliding surfaces. Lubricate caliper mounting pins and bushings with silicone grease. Install brake hose onto caliper with NEW seal washers. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
  2. Add brake fluid to reservoir. Bleed the brake system. See BLEEDING BRAKE SYSTEM . Apply brakes until brake pedal is firm. Check brake fluid level.
scientia non olet · About LEMON Manuals