Antenna Control Module: Service and Repair

ANTENNA MODULE - EXPORT

REMOVAL
1. Remove the headliner.
2. Disconnect the battery power lead connector from the antenna module.

Fig.8 Antenna Module:

3. Disconnect the antenna module connector from the integral antenna.
4. Remove the mounting screws and the antenna module.
5. Disconnect the coax lead from the antenna module.

INSTALLATION
1. Plug coax into antenna module.
2. Position antenna module onto right side upper roof rail and install screws. Tighten the screws to 8 Nm (71 in. lbs.).
3. Connect antenna module lead to the integral antenna.
4. Connect battery power supply lead to antenna module.
5. Install headliner.