Removal

REMOVAL - REAR PARKING BRAKE CABLES
1. Remove center console.
2. Lift up rear seat and carpet covering the parking brake cables.





3. Place a screw driver through the front cable eyelet and pry back on the front cable.





4. Have an assistant pry down the lock out spring through the hole in the side of the park brake lever with a small screw driver. Then slowly release the front cable.

NOTE: Their should be slack in the cable if the lock out spring is engaged.

5. Disengage rear cables ends from the equalizer.





6. Compress the cable retainers with a 13 mm wrench and remove the cable from equalizer bracket.
7. Raise and support the vehicle.
8. Remove the wheel and tire assemblies.
9. Remove the brake calipers, caliper anchors and rotors.





10. Remove the ABS sensor wiring harness from the rear brake cables.
11. Remove the cable retainer bolts from the rear spring pads.
12. Pull the cables out of the upper suspension arm brackets.





13. Push the cable in and lift up the end of cable with a small screw driver to disengage the cable from the parking brake actuator.
14. Remove the cable from the vehicle.