Removal
REMOVAL - FRONT PARKING BRAKE CABLE1. Remove center console.
2. Lift up rear seat and carpet covering the parking brake cables.
3. Place a screw driver through the front cable eyelet and drive back on the front cable.
4. Have an assistant pry down the lock out spring through the hole in the side of the park brake lever with a small screw driver. Then slowly release the front cable.
NOTE: Their should be slack in the cable if the lock out spring is engaged.
5. Disengage front cable end from the equalizer.
6. Disengage front cable end from the parking brake lever.
7. Remove the front carpet.
8. Remove front cable retainer nuts from the floor pan.
9. Compress the cable retainers with a 13 mm wrench. Remove the cable from parking hake lever bracket and equalizer bracket.