Rear Seat Back Cover

REAR SEAT BACK COVER

REMOVAL

1. Remove seat back.
2. Remove head restraint.
3. Remove head restraint caps.
4. Disengage J-straps on outboard side of seat back.
5. Disengage J-straps at base of seat back.
6. Remove push-pin fasteners attaching cover near bottom edge at latch restraint bar locations.
7. Remove screws attaching latch release handle to seat back frame.
8. Roll seat back cover upward.

Fig. 12:

9 Disengage hook and loop fasteners attaching seat back cover to seat back pad (Fig. 12).
10. Roll seat back cover upward and route latch release handle through seat back cover.
11. Separate seat back cover from seat back.
12. Separate seat back pad from seat back frame.

INSTALLATION

1. Position seat back cover and pad on seat back frame.
2. Route latch release handle through seat back cover.
3. Roll seat back cover partially downward aligning holes in seat back cover for head restraint and latch release handle.
4. Roll seat back cover downward align and engage hook and loop fasteners to seat back pad.
5. Engage J-straps at base of seat back.
6. Engage J-straps on outboard side of seat back.
7. Install push-pin fasteners attaching cover near bottom edge at latch restraint bar locations.
8. Install screws attaching latch release handle to seat back frame.
9. Install head restraint.
10. Install seat back.