LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2001 >> Cherokee Classic, 4WD, Part Time >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Bleeding Brake System >> Master Cylinder Bleeding >> On-Vehicle Bleeding

On-Vehicle Bleeding

  1. Install master cylinder onto vehicle after bench bleeding. Remove outlet port caps. Reconnect brakelines. DO NOT fully tighten brakelines at this time.
  2. Slowly force brake pedal to floor and hold in this position. Tighten brakelines. Release brake pedal. Repeat procedure until no air bubbles exist at brakelines. Tighten brakelines to specification. See TORQUE SPECIFICATIONS . Check for leaks. Bleed brake system if necessary. See MANUAL BLEEDING .
scientia non olet · About LEMON Manuals