Disabling & Activating Air Bag System
CAUTION:
When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery.
- To disable air bag system for repairs, ensure ignition switch is in OFF position. Disconnect and isolate negative battery cable. Wait at least 2 minutes after disconnecting negative battery cable before servicing air bag system.
- To activate air bag system, turn ignition switch to ON position and observe AIR BAG warning light. Warning light should come on for 6-8 seconds and then go out, indicating system is functioning properly. If warning light fails to illuminate, or illuminates and stays on, a system malfunction exists.