LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2000 >> Wrangler Sport, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> System Operation Check >> Air Bag System Check

Air Bag System Check

NOTE: Perform following check after component replacement.
  1. With battery disconnected, connect DRB scan tool to Data Link Connector (DLC). See Fig 1 . DLC is located under left side of instrument panel, near steering column. Turn ignition switch to ON position and exit vehicle with scan tool.
  2. Ensure no one is in vehicle, then connect negative battery cable. Using scan tool, read and record all active and stored DTCs. If any DTCs are present, go to DIAGNOSTICS  . If no DTCs are present, erase DTCs (active DTCs will not erase). Go to AIR BAG WARNING LIGHT CHECK  .
Fig 1: Locating Data Link Connector
G99D00854Courtesy of JEEP
scientia non olet · About LEMON Manuals