LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2000 >> Wrangler Sport, Standard >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Removal & Installation & Overhaul - NV3550 Manual Transmission >> Extension Housing >> Installation - Yoke Bushing

Installation - Yoke Bushing

  1. Align bushing oil hole with oil slot in rear housing.
  2. Tap bushing into place with Installer 6951 and Handle C-4171.
  3. Install new oil seal in housing using Installer C-3972-A (see Figure).
    Fig 1: Rear Housing Seal
    G03109726
  4. Install propeller shaft with reference marks aligned.
  5. Remove support and lower vehicle.
  6. Check transmission fluid level.
scientia non olet · About LEMON Manuals