LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2000 >> Wrangler Sport, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Self-Diagnostics - Wrangler >> Diagnostic Tests >> DTC P0432: 2/1 Catalytic Converter Efficiency (4.0L With CALIF. Emissions) >> Description

DTC P0432: 2/1 Catalytic Converter Efficiency (4.0L With CALIF. Emissions): Description

NOTE: 2/1 Heated Oxygen Sensor (HO2S) may also be referred to as an upstream oxygen sensor. 2/1 HO2S is located in rear exhaust manifold. 2/2 HO2S may also be referred to as a downstream oxygen sensor. 2/2 HO2S is located in rear exhaust pipe below front mini-catalytic converter.

Catalytic converter efficiency is monitored after engine warms up to 147°F (63.8°C), throttle has been open for 180 seconds at vehicle speed more than 20 MPH, with engine speed at 1200-1700 RPM and MAP vacuum 15-20 in. Hg. DTC will set in Powertrain Control Module (PCM) memory when PCM senses catalyst efficiency deteriorated to a predetermined value. Possible causes for DTC to set are: exhaust leak, engine mechanical problem, defective catalytic converter or upstream Heated Oxygen Sensor (HO2S) is older than downstream HO2S.