LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2000 >> Cherokee Classic, 2D Pickup >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - 7 1/8" & 7 1/3" & 7 9/16" & 7 4/5" & 8 1/4" & 8 1/2 & 8 9/10" Ring Gears >> Removal & Installation >> Rear Axle Shaft, Bearing, Seals & Retainer >> Removal (Model 198, 216 & 226 Axles)

Removal (Model 198, 216 & 226 Axles)

  1. Raise and support vehicle. Remove rear wheel(s). Remove brake drum. Remove nuts securing axle retainer plate to axle tube, and discard. Using slide hammer and Adapter (6790), remove axle shaft from axle tube.
  2. Using a 3/8" drill bit, drill a shallow hole into bearing retaining ring on axle. DO NOT drill into axle. Using a cold chisel, cut bearing retaining ring across drilled hole, and remove from axle shaft. Using a press and Bearing Remover (1130), remove bearing from axle shaft. Remove seal and retainer plate from axle shaft.
scientia non olet · About LEMON Manuals