LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls - Tests W/Codes - 3.5L) >> Self-Diagnostic System >> Entering On-Board Diagnostics >> DRB Diagnostic Mode

DRB Diagnostic Mode

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Connect DRB to engine diagnostic connector. Engine diagnostic connector is located under driver's side of dashboard, to right of steering column.
  2. Start engine (if possible). With foot on brake, move transmission shift lever through all positions, ending in Park. Turn A/C switch on and then off (if equipped).
  3. Turn engine off. Without starting engine again, turn ignition on. Using DRB, access and record trouble codes.
  4. When DRB trouble code message is obtained, refer to appropriate test number in this article. To clear trouble codes, see CLEARING TROUBLE CODES.
scientia non olet · About LEMON Manuals