LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls - Tests W/Codes - 2.5L TBI) >> Self-Diagnostic Tests >> Test TC-11E - No Vehicle Speed Sensor Signal

Test TC-11E - No Vehicle Speed Sensor Signal

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Dodge Shadow. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION TABLE. For wiring diagrams, see WIRING DIAGRAMS  .
  1. Turn ignition off. Put DRB in ohmmeter mode. Using DRB, check resistance on VSS connector Black/Light Blue wire. If resistance is more than 5 ohms, repair open in Black/Light Blue wire. Perform TEST VER-2  . If resistance is less than 5 ohms, disconnect PCM connector.
  2. Inspect PCM connector for damaged or pushed out terminals. Repair as necessary. Perform TEST VER-2. If PCM connector terminals are okay, using an external ohmmeter, check resistance of White/Orange wire between VSS connector and PCM connector terminal No. 47. If resistance is more than 5 ohms, repair open in White/Orange wire. Perform TEST VER-2. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2.
scientia non olet · About LEMON Manuals