Test TC-40B - EVAP Solenoid Control Circuit

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION DIRECTORY . For wiring diagrams, see WIRING DIAGRAMS section. After each repair, perform TEST VER-2 .

Using an external ohmmeter, check resistance across EVAP solenoid terminals. If resistance is more than 5 ohms, repair open Light Green/Black wire. If resistance is less than 5 ohms, replace EVAP solenoid and fuse No. 20.