Test TC-37B - Ignition Coil Primary Circuits
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION DIRECTORY . For wiring diagrams, see WIRING DIAGRAMS section. After each repair, perform TEST VER-2 .
- Turn ignition off. Disconnect Auto Shutdown (ASD) relay. Using an external ohmmeter, check resistance of Dark Green/Orange wire between ASD relay connector terminal "D" and ignition coil connector terminal No. 4. If resistance is more than 5 ohms, repair open Dark Green/Orange wire. If resistance is less than 5 ohms, go to next step.
- Turn ignition on. Using DRB in voltmeter mode, check voltage on ASD relay connector terminal "B" (Red/White wire). If voltage is less than 10 volts, repair open Red/White wire. If voltage is more than 10 volts, go to next step.
- Check voltage ASD relay connector terminal "A" (Dark Blue/White wire). If voltage is less than 10 volts, repair open Dark Blue/White wire. If voltage is more than 10 volts, go to next step.
- Turn ignition off. Disconnect fuel pump relay. Using an external ohmmeter, check resistance of Dark Blue/Yellow wire between ASD relay connector terminal "C" and fuel pump relay terminal "C". If resistance is more than 5 ohms, repair open Dark Blue/Yellow wire. If resistance is less than 5 ohms, replace ASD relay.