Idle Position Switch (1.8L)
WARNING: This page is about a different car, the 1994 Plymouth Laser and 1994 Eagle Talon. However, it is still accessible from the selected car via links, so may be relevant.
- Idle position switch is integral with idle speed control servo, located on throttle body. Disconnect motor position sensor connector. Using an ohmmeter, check continuity between motor position sensor connector terminal No. 4 and body ground. See Fig 1 .
- With accelerator pedal depressed, continuity should not exist. With accelerator pedal released, continuity should exist. Replace idle speed control servo assembly if switch does not test as specified.