Test 5B - Hydraulic Failure
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAM.
Turn ignition off. Disconnect CAB from HCU. See Figure. Inspect 14-pin valve block connector. See Fig 1. If 14-pin connector is faulty, repair as necessary. Perform TEST VER-1A. If any terminals are backed-out, replace HCU. Perform TEST VER-1A. If 14-pin connector is okay, replace CAB. Perform TEST VER-1A. If CAB has been replaced for this fault before, replace HCU.