Test 30B - Correcting Inoperative LTCS Green Active Lamp
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAM.
Turn ignition off. Disconnect CAB 37-pin connector. Inspect, clean or repair connector as necessary. Turn ignition on. If traction control active light glows, repair short to ground in Gray/Black wire between CAB connector and traction control active light connector. Perform TEST VER-1A. If light does not glow, replace CAB. Perform TEST VER-1A.