LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Anti-Lock Brake System) >> Self-Diagnostic Tests >> Test 30A - Correcting Inoperative LTCS Green Active Lamp

Test 30A - Correcting Inoperative LTCS Green Active Lamp

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using DRB, read traction control switch state. Depress and hold traction control selection switch on instrument panel. If DRB does not display a TRAC C SW status change, go to TEST 29A. If DRB displays TRAC C SW status change, go to next step.
  2. Using DRB, back out of TEVES ABS DIAGNOSTICS. If traction control active light glows with traction control system not selected, go to TEST 30B. If light does not glow, go to next step.
  3. Using DRB, actuate TRAC CTL ACT LAMP. If traction control active light flashes, system is operating properly at this time. Perform TEST VER-1A. If light does not flash, go to next step.
  4. Inspect fuse No. 14. See Figure. If fuse is open, repair short to ground in fused ignition feed wire. Perform TEST VER-1A. If fuse is okay, go to next step.
  5. Disconnect message center connector. See Figure. Inspect, clean or repair connector as necessary. Inspect traction control active light bulb. If bulb is faulty, replace bulb. Perform TEST VER-1A. If bulb is okay, go to next step.
  6. Turn ignition on. Using DRB, check voltage on Dark Blue/White wire at message center connector terminal No. 4. If reading is less than 9 volts, repair open in Dark Blue/White wire to message center. Perform TEST VER-1A. If reading is more than 9 volts, go to next step.
  7. Turn ignition off. Reconnect message center connector. Disconnect CAB 37-pin connector. Inspect, clean or repair connector as necessary. Turn ignition on. Connect a jumper wire between chassis ground and CAB connector terminal No. 20 (Gray/Black wire). If traction control active light does not glow, repair open in Gray/Black wire. Perform TEST VER-1A. If light glows, replace CAB. Perform TEST VER-1A.
scientia non olet · About LEMON Manuals