Test 2B - ABS AMBER WARNING LAMP CIRCUIT FAILURE

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAM.

Turn ignition off. Disconnect ABS warning light diode, located above parking brake assembly. Inspect, clean or repair connector as necessary. Disconnect CAB 37-pin connector. See Figure. Inspect, clean or repair connector as necessary. Put DRB in ohmmeter mode. Using DRB, check resistance of CAB connector terminal No. 16 (Light Green/Orange wire). See Figure. If resistance is less than 5 ohms, repair short to ground in Light Green/Orange wire. Perform TEST VER-1A. If resistance is more than 5 ohms, replace CAB. Perform TEST VER-1A.