Blade & Sealed Pin Terminals
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Remove terminal wedge lock. Insert appropriate tool at location "A". See Fig 1 and Fig 2 . Gently pry plastic locking finger away from terminal. Pull gently on wire until terminal releases.
- To install terminal, push terminal into its cavity until click is heard. Pull wire lightly to ensure terminal is locked. Reinstall terminal wedge lock. On sealed pin terminals, always reinstall seal after repairs. Replace defective terminals. See REPLACING TERMINALS.