Air Bag Control Module (ACM): Installation
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Install ACM with arrow pointing toward front of vehicle. Engage module into clip on instrument panel bracket. Install new module screws, and tighten to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article. Only use screws supplied with new ACM. Connect electrical connectors.
- To complete installation, reverse removal procedure. DO NOT connect negative battery cable at this time. Perform system operation check to ensure system is functioning properly. See SYSTEM OPERATION CHECK.