LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Air Bag Restraint System) >> Diagnosis & Testing >> Entering On-Board Diagnostics >> DRB Volt-Ohmmeter Mode

DRB Volt-Ohmmeter Mode

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. To access volt-ohmmeter mode of DRB, connect Red volt-ohmmeter test lead to Red port, located on right top side of DRB.
  2. To access voltmeter, press VOLT/OHM key once. DRB is now in voltmeter mode. Touch test probe to connector or wire to be measured. Read voltage on DRB display. When voltage testing is complete, press VOLT/OHM key 3 times to exit voltmeter mode.
  3. To access ohmmeter, press VOLT/OHM key twice. DRB is now in ohmmeter mode. Touch test probe to connector or wire to be measured. Read resistance to circuit ground on DRB display. When resistance testing is complete, press VOLT/OHM key twice to exit ohmmeter mode.
scientia non olet · About LEMON Manuals