NO RESPONSE Message
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect BCM connector (Bone color). With DRB in voltmeter mode, ensure voltage at terminal No. 19 (Pink wire) is more than 10 volts. If voltage is more than 10 volts, go to next step. If voltage is less than 10 volts, repair fused battery feed circuit back to junction box. Perform VERIFICATION TEST .
- If voltage was more than 10 volts, switch DRB to ohmmeter mode. Ensure resistance at terminal No. 21 (Black wire) is less than 5 ohms. If resistance is less than 5 ohms, go to next step. If resistance is more than 5 ohms, repair system ground to BCM. Perform VERIFICATION TEST .
- Ensure resistance at terminal No. 14 (Black/Light Green wire) is less than 100 ohms. If resistance is less than 100 ohms, go to next step. If resistance is more than 100 ohms, repair signal ground to BCM. Perform VERIFICATION TEST .
- With ignition switch in ON position and DRB in voltmeter mode, ensure voltage at terminal No. 8 (Violet/Brown wire) is more than one volt. If voltage is more than one volt, go to next step. If voltage is less than one volt, repair open Chrysler Collision Detection Bus (CCD+) circuit to BCM. Perform VERIFICATION TEST .
- With ignition switch in ON position and DRB in voltmeter mode, ensure voltage at terminal No. 7 (White/Black wire) is more than one volt. If voltage is less than one volt, repair open Chrysler Collision Detection Bus (CCD-) circuit to BCM. Perform VERIFICATION TEST . If voltage is more than one volt, replace BCM. Perform VERIFICATION TEST .