A/C System Charge Level Test: DRB
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Attach clamp-on thermocouple to liquid line as close to condenser outlet as possible. Attach DRB to data link connector located right of steering column under instrument panel. See Figure .
- Set parking brake and place transaxle in Park. Idle engine at 700 RPM. Set A/C controls to outside air, full cool and high blower speed. Turn A/C button on and open windows. Operate system for a few minutes to allow system to stabilize.
- Place a piece of cardboard over part of condenser to set A/C pressure to approximately 260 psi (18.3 kg/cm2 ). This will stop cooling fans from alternating speeds and maintain constant pressure.
- DRB will automatically calculate system charge. Depending on system charge condition, corrections are made 2 ounces at a time. Each time a correction is made, recheck readings to ensure proper charge. Total system capacity is 28 ounces.