Removal & Installation
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove left and right underpanel silencer/ducts and floor console. Remove center floor heat adaptor duct and rear seat heat forward adaptor duct. Loosen center support bracket and pry rearward to gain access to actuator.
- Remove actuator screws and pull actuator straight down. Note shaft key position for installation. Disconnect actuator connector. To install, reverse removal procedure. When installing actuator, shaft must be reinstalled in original position.