Removal & Installation
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove A/C-heater assembly. See A/C-HEATER ASSEMBLY .
- Remove recirculation door actuator, recirculation door and housing. Remove upper housing screws and upper half of A/C-heater housing. Remove evaporator from lower half of housing.
- Using a new gasket, transfer expansion valve onto new evaporator. Transfer evaporator temperature sensor to the same location as on previous evaporator. Ensure evaporator has 2 ounces of new refrigerant oil. To install, reverse removal procedure. Evacuate and recharge A/C system.