Removal & Installation (Except New Yorker)
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect refrigerant lines and receiver-drier at condenser. Plug or cap open lines. Remove bolts and inlet tube bracket screw.
- Spread bracket open and remove condenser. Avoid bending or breaking condenser inlet tube. To install, reverse removal procedure. Add one ounce of refrigerant oil to new condenser. Evacuate and recharge A/C system.