Removal & Installation
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect harness connector. Rotate transducer counterclockwise using 3/4" open end wrench. There may be a slight discharge of trapped pressure from fitting. It is not necessary to discharge refrigerant system. To install, reverse removal procedure. Tighten transducer to 50 INCH lbs. (5.6 N.m).