Vehicle Equipment & System Problem Id
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Connect DRB to data link (diagnostic) connector. See Figure . Turn ignition on. With DRB, select body system. If DRB does not display BUS OPERATIONAL message, check body control computer for bus failure messages. See appropriate article in ENGINE PERFORMANCE section. If BUS OPERATIONAL message is displayed, go to next step.
- Select body controller. Select ATC system. If DRB displays NO RESPONSE, go to TEST 18A: IGNITION SWITCH OUTPUT CIRCUIT. If NO RESPONSE is not displayed, go to TEST 17A: AUTOMATIC TEMPERATURE CONTROL.
NOTE:
See TEST 17A and TEST 18A in TROUBLE SHOOTING section.