LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (A/C-Heater System - Automatic) >> Removal & Installation >> Condenser >> Removal & Installation (New Yorker)

Removal & Installation (New Yorker)

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove radiator closure panel sight shield, and right and left headlamp modules. Drain engine coolant. Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove upper radiator crossmember and radiator hoses. Disconnect and plug automatic transaxle cooler lines. Disconnect cooling fan connector from RFI module.
  2. Disconnect refrigerant lines and receiver-drier at condenser. Plug or cap open lines. Access upper radiator mounting screws through headlamp module bracket and remove screws. Remove radiator and condenser assembly from vehicle. Separate radiator and condenser. Avoid bending or breaking condenser inlet tube.
  3. To install, reverse removal procedure. Tighten radiator mounting screws to 105 INCH lbs. (12 N.m). Tighten radiator-to-condenser mounting screws to 45 INCH lbs. (5 N.m). Add one ounce of refrigerant oil to new condenser. Evacuate and recharge A/C system.
scientia non olet · About LEMON Manuals