LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Controls - Tests W/Codes - 2.5L Flex Fuel) >> Self-Diagnostic Tests >> Test TC-11E - No Vehicle Speed Sensor Signal

Test TC-11E - No Vehicle Speed Sensor Signal

WARNING: This page is about a different car, the 1994 Plymouth Acclaim and 1994 Dodge Spirit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION DIRECTORY TABLE  . For wiring diagrams, see WIRING DIAGRAMS  .
  1. Turn ignition off. Put DRB in ohmmeter mode. Using DRB, check resistance on VSS connector Black/Light Blue wire. If resistance is more than 5 ohms, repair open in Black/Light Blue wire. Perform TEST VER-2. If resistance is less than 5 ohms, disconnect PCM connector.
  2. Inspect PCM connector for damaged or pushed out terminals. Repair as necessary. Perform TEST VER-2  . If PCM connector terminals are okay, using an external ohmmeter, check resistance of White/Orange wire between VSS connector and PCM connector terminal No. 47. If resistance is more than 5 ohms, repair open in White/Orange wire. Perform TEST VER-2. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2.
scientia non olet · About LEMON Manuals