Diagnostic Fault Codes (Messages): Notes
WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
If any of following ACM diagnostic fault codes appear, replace ACM.
- SAFING SENSOR OPEN
- SAFING SENSOR SHORT
- INTERNAL DIAGNOSTIC #1
- INTERNAL DIAGNOSTIC #2
- INTERNAL DIAGNOSTIC #3
- INTERNAL DIAGNOSTIC #4
- AECM ACCELEROMETER
- AECM INTERNAL DIAGNOSTIC #2
- AECM OUTPUT DRIVER
- AECM STORED ENERGY
- INTERNAL LAMP DRIVER
- LOW STORED ENERGY DRIVER
- LOW STORED ENERGY PASSENGER
If any of following ACM diagnostic fault codes appear, perform required test procedure under DIAGNOSTIC CHARTS, starting with TEST 1A - TESTING SYSTEM FUNCTION.
- NO IGNITION RUN ONLY
- TWO FRONT SENSORS OPEN
- DRIVER-SIDE SQUIB OPEN
- PASSENGER-SIDE SQUIB OPEN
- DRIVER-SIDE SQUIB SHORT
- PASSENGER-SIDE SQUIB SHORT
- NO BCM BUS MESSAGE
- FRONT SENSOR SHORT
- ONE FRONT SENSOR OPEN
- WARNING LAMP INTERFACE #1 OR #2
- NO CCD COMM
- WARNING LAMP CIRCUIT OPEN/SHORTED