Test 3C: Antilock Lamp Circuit

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS .

Turn ignition off. Disconnect CAB 60-pin connector. See Figure. Disconnect ABS relay. Put DRB in voltmeter mode. Using DRB, check voltage between chassis ground and CAB connector terminal No. 15 (Light Green/Orange wire). If reading is more than 9 volts, replace CAB. Perform TEST VER-1A: SYSTEM VERIFICATION TEST . If reading is less than 9 volts, repair open in Light Green/Orange wire. Perform TEST VER-1A: SYSTEM VERIFICATION TEST .