Test 10C: Pump/Motor Circuit

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS .

Using DRB, stop MOTOR PUMP actuation. Turn ignition off. Remove pump/motor relay. Disconnect CAB 60-pin connector. Put DRB in ohmmeter mode. Using DRB, check resistance of CAB 60-pin connector terminal No. 16 (Gray wire). If resistance is more than 5 ohms, repair open in Gray wire. Perform TEST VER-1A: SYSTEM VERIFICATION TEST . If resistance is less than 5 ohms, replace CAB. Perform TEST VER-1A: SYSTEM VERIFICATION TEST .